Diestco Heavy Duty Powerchair Covers

• Lightweight cover that is made of 600 x 300 polyester with PVC backing that provides the highest level of protection for your powerchair from weather and dust
• Works great on lifts or for storing outside
• Easy to get on and off your chair, simply slip the cover over your vehicle and pull the elastic down under your chassis
• Pull the cord lock so that it is tight around the bottom
• Dimensions: 38" H X 18" W X 44" L
• Circumference: 124"

Large Power Chair Cover with Back Slit

• Designed to accommodate a docking device while the device is in operation
• The back slit has a 1” hook-and-loop closure along the entire length for complete closure while on the vehicle
• Side release buckles, located at the bottom of the cover to buckle, cinch, and secure for maximum security

For extra security, when transporting your vehicle on the back of your car or van, tie down the bottom by hooking bungee-type cords (not included) through the bottom belt loops. This will reduce the amount of excess room under the cover and prevent the cover from billowing up at high speeds. This is needed because if your cover is flapping excessively at high speeds, the life of the cover will be greatly reduced.

The following statements are intended to be used as guidelines in deciding which cover would work best for you. Note that this is a heavy duty cover and you will need a 1" webbing belt through belt loops to tighten it. Also, depending on your vehicle, the cover may not fit over the wheels.

Photos represent all of the powerchair covers since they only differ in size and look almost identical in photos.